![]() ![]() Be sure to knock off any sharp edges and corners too. I then sanded it through the stages up to 600 grit. I am using 3/4" X 1/2 " aluminum L channel cut to the same width as the fret board. ![]() While I wait for my client to send some parts he wants on this I started work on the bridges. The wonderful thing about building a guitar from scratch is that there are so many little projects involved. Rotary tool with steel burr and sanding drums.Īn occasional adult beverage of your choosing (I do not endorse drinking and operating tools) Several small bits of maple mostly 4" X 2" X 1/8" (pick-up cover plate and control plate)Ģ pieces aluminum L channel, 2 1/4" X 1/2" X 3/4" ( bridge and nut)ġ single coil pick up with adjustment screws and springs ![]() Here is a list of tools and materials I used in this build in no particular order, of course you are free to substitute any where you wish: I would also like to acknowledge the web site for providing the basic guide lines I followed, Disclaimer power tools and sharp cutting tools will be used and I take no responsibility for people who use these things carelessly, read and understand manufacture's instructions and safety guidelines for their proper and safe use. In this, my first Instructable, I will attempt to chronicle the construction of a simple Lap Steel guitar. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |